Reading: How to Install a Receptacle
first, where will the office derive from ? You can tap office for a new receptacle from an existing receptacle. If doing this may cause the circuit to overload or if there is no handily located receptacle, tap baron from a articulation corner in the basement or a nearby light fastness or throw. Or, if one or more new receptacles supply heavy ability users, run cable all the way to the serve panel and install a newfangled circumference. besides consider the adenosine monophosphate of your wall socket. When connecting to a 15-amp racing circuit, install a criterion receptacle and 14-gauge wire. When connecting to a 20-amp circuit, use 12-gauge wire and a especial 20-amp receptacle. however you grab world power and route cables, make indisputable the cable is securely clamped at each end and the reason wires are connected correctly. Expect to spend about 2 hours running cable and making connections for your new receptacle. You ‘ll need to know how to strip and connect wires to terminals, install boxes, and run cable through walls and ceilings.
What You Need
- Voltage tester
- Fish tape
- Long-nose pliers
- Lineman’s pliers
- Utility knife
- Stud finder
- Torpedo level
- Tape measure
- Pry bar
- Drywall saw or jigsaw
- New receptacle
- Remodel box and clamps
- Wire nuts
- Electrician’s tape
- Protective nailing plates
- Cable staples
Step 1: Shut Off Power and Remove Receptacle
Shut off exponent to the circuit. Cut and drill a pathway for the cable. Pull out the receptacle you ‘re grabbing ability from and test to make sure power is not present. Move the receptacle to the side or gulf and remove it.
Step 2: Install Remodel Box
Cut a hole for a recast box. Run cable from the area near the existing box to the hole, clamp the cable television to the box, and install the new box.
Read more: My Painted Bathtub 5 Years Later
Step 3: Strip and Clamp
Pry up a smasher sluggard in the old box and twist it out with pliers. ( If you ca n’t do this, remove the corner and replace it with a recast box. ) Remove the sheathe from the cable, strip the wires, and attach a connection clamp to the cable. Push the cable into the box and fasten the clamp.
Step 4: Connect Wires
Strip and run cable into the existing box and tighten the cable clamp. Connect the fresh wires to existing wire. Attach the ground wires using a pigtail. Connect the white wire to the available eloquent terminal and the black electrify to the brass section one.
Step 5: Wire New Receptacle
Wire the newly receptacle. Connect the ground wire to the crunch screw, the white electrify to the eloquent terminal, and the black wire to the boldness terminal.
How to Wire a Middle-of-Run Receptacle
Read more: How To Skim Fat Off Of Broth Recipes
If the existing receptacle box has two cables and there are no available terminals on the receptacle, disconnect all the wires. Hook up pigtails and connect the pigtails to the terminals .